Oven Probe Specificationsalso Known As A Temperature Sensor. This Part Is Used To Detect The Temperature Within The Oven Cavity. **The Following Instructions Only Apply If The Connector Piece Is Different Than The Original. **Prior To Cutting The Leads, Please Check The Length Of The Wire You Will Need. 1. Cut The Leads On Your Original Sensor And The Replacement Sensor. Be Sure To Leave Enough Length To Strip And Splice The New Probe And Original Connector Together. 2. Strip The Insulation, Or Wire Cover, Back Approximately 1/4 Inches On The New Probe And Original Connector. 3. Twist The Ends Of Your New Probe And Original Connector Together4. Use A Wire Nut, Or Another High Heat Fastener To Cover Your Exposed Wires. 5. Install Your New Oven Probe And Re Assembly Your Oven. This Part Fixes The Following Symptoms: This Part Fixes The Following Symptoms: Oven Is Too Hot | Little To No Heat When Baking | Will Not Start | Oven Not Heating Evenlythis Part Works With The Following Products: This Part Works With The Following Products: Range, Wall Oven, Microwave Oven Combo. This Part Works With The Following Products: This Part Works With The Following Products: Frigidaire, Tappan, Kenmore, Gibson. Part, 5304497424 Replaces These: Part, 5304497424 Replaces These: Ap5951458,3018012,3018668,316072000,316101700,316111200,316111202,316134900,3202382,3204593,5304414780,P295003Cross Parts: 3018012, 316111202, 316101700, 5304414780, 316072000, 316134900, Ap5951458, 3202382, Ps10057397, 3018668, P295003, 316111200, 3204593