Tub Seal Specificationsthe Main Tub Seal Is Located Between The Transmission And The Outer Tub. Its The Primary Water Seal In The Outer Tub For The Transmission-Shaft. If Your Washer Is Leaking During The Fill Cycle, Or At Agitation Time, Your Tub Seal May Need To Be Replaced. You Can Check If The Tub Seal Needs To Be Replaced By Watching That Area During An Actual Fill Cycle. Take Off The Front Panel, Or If It Is A Front-Loading Washer, The Rear Panel. Without Touching The Washing Machine, Observe The Place Where The Shaft Of The Transmission Comes Into The Tub And The Weep Holes At The Housing Of The Rear Bearing. If There Is Water Leaking, The Tub Seal Is At Fault. Note: This Seal Is Difficult To Replace And Should Probably Be Installed By A Qualified Technician. This Part Fixes The Following Symptoms: This Part Fixes The Following Symptoms: Leaking | Noisy | Marks Left On Clothes | Pumps But Will Not Spinthis Part Works With The Following Products: This Part Works With The Following Products: Washer. This Part Works With The Following Products: This Part Works With The Following Products: General Electric, Hotpoint. Part, Wh02x10383 Replaces These: Part, Wh02x10383 Replaces These: Ap5645738,Wh02x10032,Wh02x1196,Wh2x1196Cross Parts: Wh02x10032, Ap5645738, Wh02x1196, Wh2x1196, Wh02x10383